There are 57 products.

generators

consists of stator, rotor, kotushki excitation krishek front and rear, of the rectifier, the drive pulley and the impeller.
stator consists of a stack of steel plates. On the inner surface of the stator teeth 10 are located with stator windings on each coil. In phase two serially connected coils. The ends of the output phase conductors of flexible cable lugs.
rotor manufactured as a six-pointed star made of steel plates and the shaft for compression.
rotor shaft is located in the ball-bearing grease Closed-disposable design. In the front end of a shaft mounted drive pulley to which is attached an impeller for cooling the generator and behind an impeller cooling the rectifier unit. For this purpose also korpusse arranged ribs. The excitation winding joined to the front cover. One end of it is attached to add. and output terminal of the generator voltage regulator and the other terminal to a voltage regulator.
rectifier unit is mounted on the rear cover and Comp. it from a power and additional rectifiers napryazheniyai margin of seasonal control switch voltage regulator block "ZIMA_LETO". Structurally, power and additional vipryamiteli installed in one korpusі. a voltage regulator and a switch unit disposed on Krischke.
The rectifier zakrpeleny housing 5 opposite polarity diodes, and direct diodes 5 plastinі polarity. Insertion of diodes are connected by a bus phase terminals of the stator windings. Conclusions reverse polarity diodes are connected to the mass and direct polarity with diodes pin generator Clem.

Showing 1 - 57 of 57 items

We call you back

MOTOR-AGRO recommends

Parts manufacturing facilities for tractors and combines on your drawings!

If it is not found in the needed parts catalog, the Motor-Agro experts as soon as possible ready to make it in the required amount according to your drawings.

For more information and orders please call directly to the engineering department:
+38 057 714 64 98