Clutch A-41

Clutch Parts A-41 tractor DT-75

The shafts, forks, hydraulic actuators, drives, baskets, caps, springs...


ᐉ Clutch A-41 from Motor-Agro

Parts clutch A-41 and A-01 for a tractor DT-75

The clutch is necessary to disconnect the engine crankshaft and shaft power transmission. This need for short stops of the tractor and the inclusion of various programs, and for the gradual, ie shockless compound of the rotating shaft with a fixed transmission power mechanism. The clutch protects the motor and the power transmission from failure during a sharp change in the number of revolutions of the engine or during a sudden and sharp change in velocity. The A-41 and A-01, using 2-MS disc with an outer diameter of the friction discs 350 mm. Are permanently closed.

The clutch is installed in front of the flywheel plane. The outer part is covered by its cover. Leading parts consist of a flywheel, extreme and middle leading cast iron discs, which with the help of 3 spikes leading pads are attached to the clutch cover.

The slave of the presented steel wheels with friction linings, which can easily move splined shaft MS. Release lever fastened with bolts through the thrust washers and nuts that are simultaneously being adjusting. On pressing on the support foot squeezing levers ends with a short press on the shoulder thrust washers and nuts thereby diverting extreme presenter. disk. Average drive plate moves away from the flywheel to the clutch off under the action of squeezing the springs installed in the flywheel holes. When the clutch is engaged, the respective discs are compressed spring force the screws are screwed all the way into the middle disk, and then unscrew 1 turn and nut lock it allows off coupling medium drive into the correct intermediate position.

During the off switch on the release lever pushes off clutch, in which the body is pressed into the angular contact ball bearing № 46118. casing CF easily shifted by means of the fork axially of the shaft by means of a tubular shank rear bearing housing. The shaft rotates in 2 rolling bearings - a roller № 292208 without zapressovanym inner ring in the bore of the flywheel and back directly into the housing. Front bearing is sealed and stamped samopodzhimnym gland washer.

The grease is pumped through the radial hole on the flywheel. For ventilation of the cavity located on the lid of the hatch sleeve, which is closed with shutters. Through this hatch make the adjustment and lubrication of the thrust bearing. During assembly and wear in manual adjustment is necessary tripping device.

Full speed is obtained by adjusting the lengths of the rods, which are connected with the clutch lever and pedal tractor and must be in the range of 14-18 mm. Provided stroke equal to 14 mm, the shaft is rotated by hand. In order to eliminate imbalances need static balancing together with the housing, the drive plate, the release lever and power spring with glasses. For this purpose, the clutch assembly is attached to the disk device on two pins and produce balancing of the machine by screwing bolts into different masses cover up to 400 g/cm.

Filter by
Manufacturers
more... less
Filter
Contacts in Ukraine

Ukraine, Kharkiv, Autogenna, 12a

from 830 to 1700 GMT+3

sbyt@motor-agro.com.ua

+38 050 300 00 19

+38 067 572 17 11

+38 057 714 65 14


Didn't find the necessary spare part for your tractor, combine harvester, special machinery or equipment?

Just call MOTOR-AGRO specialists at the numbers listed on this site - we will help

Product added to compare.