Parts for Combine Header DON-1500
Boots, shafts, plugs, bushings, heads, wheels, stars, rings, blades, beams, gears, UGS, knives cutterbar, chopper knives, forks support , axles, pins, plates, leads, bearing coupling part, clamps, gaskets, springs, levers, blade segments, earrings, Kit, pipes, safety devices, joints, pulleys, pins, cheeks, panels, plates, eccentric...
Parts header for harvesting DON-1500
Maize harvester necessary for cutting, forming and conveying grain mass flow equal to the threshing apparatus. When separate harvesting header is needed for the selection of grain mass from the roll and feed it into the threshing apparatus. Header produce various sizes differing widths.
suspension mechanism and balancing header harvester DON
The design allows to work with a field relief copying or without it. In the case of work with copying the header body abuts on the sliding surface of the field and supporting a predetermined cutting height shoes. balancing mechanism design automatically provides post. shoes level of pressure on the ground with any distortions header. Longitudinal copying it from the deviation of header horizon. position upwards - downwards) is ± 150 mm and depends on the working width of the header. Cross copying (transverse tilt) header manager. the width of its capture.
guide shoes is not very good glide on both loose soil and wet, increasing fuel consumption on movement. In such cases, the mechanism is turned off and continue to work with a margin of boots on the ground. Without a copier. and work on uneven terrain.
Cutting required for plants cut. On header put: segment-cutting finger gated element bezpaltsevoy or segment-finger open cutting element. On a segment-finger cutting machine from the set E-ton segment with a movable knife and short fingers with inserts. Knives cutting machines reciprocating movement. During the combine in the gaps between the fixed elements of the cutting device consists of stems of plants, the movable member is pressed and cut them.