replacements feederhouse for a combine DON-1500
beater spacers, shafts, hubs, sprockets, drive shafts, reversing mechanisms laths, the inclined chamber, the guide fingers, finger mechanisms, levers, clamps, Kit , conveyors, safety devices, pulleys...
Parts feederhouse harvester DON-1500
is needed for transporting the grain mass from the spacer directly into the thresher. Includes a cover to the housing, the drive shaft, the lower the output shaft and the chain-and-slat conveyor. To connect to the spacer body equipped with hooks and screws for the screed. Conveyor movement is given via a pulley arranged on it a slip clutch with torque 150 Nm. The shaft requires both drive chain transmission parts reaper.
Floating conveyor harvester feeder is needed for transporting the stems of the screw in the receiving chamber thresher and installed in the feeder. It includes input and output shafts, which is worth 3 stars. Asterisks dressed bush roller chain wear on the sprocket with steel straps attached to a chain in a staggered manner. Motion to be smooth over the lower circuit branches mounted saddle-girth Polozkov, pressing Polozkov to chains gives spring which acts on the tensioning lever DEVICE.
Slave conveyor shaft is hung in an inclined housing for a spring and can be adapted to the thickness of the layer of stems. At receipt of a thick layer of grain mass lying lower shaft. chain stretch is set screws so that the length of the compression tension spring. DEVICE status. 90 ... 95 mm. For preserved. the gap between the slats and the bottom in the range of 5 - 10 mm, between the nuts and bolts Trailing sidewall gon camera pose washers. The spring suspension is necessary to clamp the driven shaft so he could rise up to 50 mm and float over the grain mass.
The drive pulley is equipped with a slip clutch transmission switch-off in case of overload. conveyor speed of 2.91 m/s.